Product ID:UC65040 ARCHITECTURAL GLOSS WHITE TRIM
MSDS Date:04/05/1993
FSC:8010
NIIN:00-515-1596
MSDS Number: BSFPD

PPG INDUSTRIES, INC

4325 ROSANNA DRIVE
ALLISON PARK, PA 15101
US

Emergency Phone: 304-843-1300

Info Phone: 412-492-5555/800-441-9695

Cage: DO894

PPG INDUSTRIES, INC.

9 ALLISON PARK, PA 15101 US

Telephone: 412-592-5555

Cage: DO894

TITANIUM DIOXIDE 2101

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 30-35%

OSHA PEL 10 MG/M3

ACGIH TLV: 10 MG/M3

HYDROTREATED LIGHT DISTILLATE

CAS: 64742-47-8

Fraction By Weight: 10-15%

XYLENE (SARA III) (RQ 1000 LBS)

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 1-2%

OSHA PEL 100 PPM/STEL 150 PPM

ACGIH TLV: 100 PPM/STEL 150 PPM

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

MINERAL SPIRITS

CAS: 64741-92-0

Fraction By Weight: 10-15%

FILM FORMERS, RESINS, AND ADDITIVES

Fraction By Weight: 35-40%

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGESTION: HARMFUL OR FATAL. EYE: EYE
IRRITATION. SKIN: MODERATE SKIN IRRITATION. INHALATION: VAPOR/SPRAY
MIST HARMFUL. IRRITATES EYE, NOSE & THROAT. IRRITATION OF RESP
SYSTEM & PERMANENT BRAIN & NERV OUS SYSTEM DAMAGE. CONCENTRATING &
INHALING CONTENTS CAN BE HARMFUL OR FATAL.
Explanation of Carcinogenicity:HYDROTREATED LIGHT DISTILLATE IS
CARCINOGENIC ACCORDING TO CRITERIA ESTABLISHED BY UNKNOWN SOURCE.
Effects of Overexposure:EYE WATERING, HEADACHE, NAUSEA, DIZZINESS,
UNCOORDINATION ARE INDICATIONS THAT SOLVENT LEVELS ARE TOO HIGH.
REDNESS, ITCHING, BURNING SENSATION AND VISUAL DISTURBANCES MAY
INDICATE EXCESSIVE EYE CONTA CT. DRYNESS, ITCHING, CRACKING,
BURNING, REDNESS, AND SWELLING ARE CONDITIONS ASSOCIATED WITH
EXCESSIVE SKIN CONTACT.

First Aid:INGESTION: DONT INDUCE VOMITING. EYE: FLUSH EYES IMMEDIATELY
WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES. SKIN: FLUSH
IMMEDIATELY WITH PLENTY OF WATER FOLLOWED BY WASHING WITH SOAP &
WATER. INHALATIO N: REMOVE TO FRESH AIR. APPLY ARTIFICIAL
RESPIRATION & OTHER SUPPORTIVE MEASURES AS REQUIRED. OTHER: IF ANY
TYPE OF OVEREXPOSURE, CONTACT POISON CONTROL CTR, EMERGENCY ROOM OR
DR. HAVE MSDS AVAILABLE.

Flash Point Method:PMCC
Flash Point:110F,43C
Lower Limits:1.0
Extinguishing Media:NFPA CLASS B EXTINGUISHERS (CO2, DRY CHEMICAL,
UNIVERSAL AQUEOUS FILM FORMING FOAM) FOR CLASS II COMBUSTIBLE
LIQUID FIRE
Fire Fighting Procedures:WATER SPRAY MAY BE INEFFECTIVE, USE (FOG
NOZZLES PREFERRED) TO COOL CLOSED CONTAINERS TO PREVENT PRESSURE
BLDUP, AUTOIGNITION, EXPLOSION W/HEAT. WEAR SCBA.
Unusual Fire/Explosion Hazard:KEEP CONTAINER CLSD. KEEP FROM
HEAT/IGNITION SOURCES. CLOSED CONTAINER MAY EXPLODE W/HEAT. DONT
APPLY ON HOT SURFACES. TOXIC GASES MAY FORM W/FLAME/HOT SURFACES

Spill Release Procedures:PROVIDE MAXIMUM VENTILATION. ONLY PERSONNEL
EQUIPPED WITH PROPER RESPIRATORY, SKIN, & EYE PROTECTION SHOULD BE
PERMITTED IN AREA. REMOVE ALL IGNITION SOURCES. TAKE UP SPILLED
MAT'L WITH SAWDUST, VERMI CULITE, OTHER ABOSRBENT MAT'L & PLACE IN
CNTNRS.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LARGE
QUANTITIES IN BUILDING DESIGNED & PROTECTED FOR STORAGE OF NFPA
CLASS II COMBUSTIBLE LIQUIDS.
Other Precautions:IF MATERIAL PART OF MULTIPLE COMPONENT SYSTEM, READ
MATERIAL DATA SHEETS FOR OTHER COMPONENT(S) BEFORE BLENDING AS
RESULTING MIX MAY HAVE HAZARDS OF PARTS. GROUND CONTAINERS WHEN
POURING. AVOID FREE F AL OF LIQUIDS IN EXCESS OF FEW INCHES.

Respiratory Protection:OVEREXPOSURE TO VAPOR MAY BE PREVENTED BY
ENSURING VENT CONTROLS, VAPOR EXHAUST OR FRESH AIR ENTRY.
NIOSH/MSHA (TC-23C) AIR PURIFYING OR AIR SUPPLIED (TC-19C)
RESPIRATOR MAY ALSO REDUCE EXPOSURE. READ RESPIRATOR MFR'S
INSTRUCTIONS.
Ventilation:GENERAL DILUTION OR LOCAL EXHAUST TO KEEP CONCENTRATION
BELOW TLV, PEL, LEL & REMOVE DECOMPOSITION PRODUCTS.
Protective Gloves:NEOPRENE, NITRILE, LATEX RUBBER GLOVES
Eye Protection:CHEM SPLASH GOGGLES
Other Protective Equipment:CLEAN/DISCARD CONTAM CLOTHING & SHOES. WEAR
PROTECTIVE CLOTHING: IMPERMEABLE APRON (NEOPRENE, NITRILE, LATEX
RUBBER).
Supplemental Safety and Health

HCC:F4
Boiling Pt:B.P. Text:138 TO 242C
Vapor Pres:1.2
Vapor Density:> AIR
Spec Gravity:1.24
Evaporation Rate & Reference:11 (BU AC=1)
Solubility in Water:0.0%
Appearance and Odor:VISCOUS LIQUID WITH AN ODOR CHARACTERISTIC OF THE
SOLVENTS LISTED IN INGREDIENT
Percent Volatiles by Volume:44.30

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG
OXIDIZING AGENTS.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS DECOMPOSITION
PRODUCTS WHEN HEATED. WELDING, BRAZING, FLAME CUTTING MAY PRODUCE:
CARBON MONOXIDE.

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, PROVINCIAL AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED WAS TE MANAGEMENT FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.